Configuring Interfaces ASA 5500

Basic Interface configuration :

Step 1 To enter Interface configuration mode, in global configuration mode enter the interface command with the default name of the interface to configure. In the following example the interface is ethernet0. hostname(config)# interface ethernet

(int eth )

hostname(config-if)#

Step 2 To set the IP address and subnet mask for the [...]

March 31st, 2009 | Tags: | Category: Cisco | Leave a comment

Performing Password Recovery for the ASA 5500 Series Adaptive Security Appliance

Performing Password Recovery for the ASA 5500 Series Adaptive Security Appliance

To recover from the loss of passwords, perform the following steps:

Step 1 Connect to the security appliance console port

Step 2 Power off the security appliance, and then power it on.

Step 3 During the startup messages, press the Escape key when prompted [...]

March 31st, 2009 | Category: Cisco | Leave a comment